Batch processor doesn't start when leaving maintenance mode

Classic Servoy
1

Hi, we use a couple of batch processors. Enable/Disable batch processor clients on server startup is Enabled on our server. So when we restart, or stop and start, the batch processors start automatically. I use maintenance mode when I update a solution and don’t want users to connect. When I leave maintenance mode the batch processors don’t start. I did some tests in Servoy version 5.1.4 i2-build 966, Servoy version 5.2.2 -build 1002 and Servoy version 5.2.6 -build 1011. The behaviour is the same in all versions.

Is there a reason why batch processors do not start automatically when you leave maintenance mode?
Now I have to start them manually every time I use maintenance mode.

2

yes, we see the same, after a restart, that the batch processors not always auto-start…
Manually starting it again, always fixes it…

3

Thanks for your quick response. I don’t have problems after a restart. When I restart the server the batch processors start automatically. When I leave maintenance mode, they don’t. It would be easier when they do.

4

make a case for this.

5

Case ID 367735

6

Batch processors also don’t stop when entering maintenance mode, so why would you have them start automatically when you exit maintenance mode?

Paul

7

The status of my batch processors changes to “Not running” when I enter Maintenance Mode. After leaving Maintenace Mode I have to press Start to start them again.